What should be paid attention to when using plastic granulator?

The plastic granulator needs to be preheated before use. Generally, it takes about 40 minutes to warm up, and the temperature rises to the point where the V-belt can run freely by manually pulling it. But this is still not able to boot, and continue to warm up for ten minutes before it can be turned on. The waste plastic put into the equipment must be uniform, and the processing speed of the machine and the speed of waste input must be well coordinated, otherwise it will affect the quality of plastic particles and the production capacity of the equipment.

After the plastic granulator works normally, its working temperature should be kept stable and not fluctuated, which will cause the machine efficiency to be unstable and prone to failure. Therefore, temperature control is very important for the proper operation of the equipment. When the device is not in use, be sure to completely cut off the power supply. At the same time, write down the wire plug of the machine head so that it can be heated separately for the next use.

Nanjing Tengda Machinery Co., Ltd. highlighted the need to foster a human openness to technological innovation.
Super quality are in offer at TENGDA Extruder Machine Manufacturers, welcome to visit us.
can be used in a wide variety of ways.
The best way of plastic extruder machine manufacturers is to get a extruder machine manufacturers Application.