Degradable extrusion granulator needs maintenance

The maintenance of the reducer of the degradable extrusion granulator is the same as that of the general standard reducer. It is mainly to check the wear and failure of gears, bearings, etc. The gear box should use the lubricating oil specified in the machine manual, and add oil according to the specified oil level. Too little oil will cause poor lubrication and reduce the service life of the parts; too much oil will cause high heat, high energy consumption, and easy deterioration of oil. , also make the lubrication ineffective, resulting in the consequences of damage to the parts.

The twin-screw extruder is not allowed to run empty, so as not to damage the screw and the machine. If there is an abnormal sound when the extruder is running, Xiaoben's entrepreneurial story. Stop immediately for inspection or repair. Strictly prevent metal or other debris from falling into the hopper, so as not to damage the screw and barrel. In order to prevent iron impurities from entering the barrel, a magnetic frame can be installed at the feeding port of the material entering the barrel; or the material can be screened in advance. When the extruder needs to be stopped for a long time, the screw of the twin-screw extruder should be placed in the machine and not taken out, and the working surface of the machine head and other working surfaces should be coated with anti-rust grease. Regularly calibrate the temperature control instrument to check the correctness of its adjustment and the sensitivity of the control.

The twin-screw extruder needs regular maintenance during its use. Generally, the twin-screw extruder will be shut down after 2500-5000 hours of continuous operation. Parts up to the specified wear limit, repair damaged parts.