The main matters of using twin screw extrusion granulator

If the twin-screw extruder needs to be started for the second time, the ash outlet must be cleaned before starting, which can effectively prevent the powder from entering the bearing and affect the normal use of the equipment. In addition, the debris inside the equipment also needs to be cleaned up so that the equipment can work better.

In order to ensure the normal operation of the twin-screw extrusion granulator, you also need to check its mechanical bearings to see if there is enough lubricating oil. If not, it needs to be added in time, and the lubrication degree of the machine bearing must be guaranteed. Otherwise, it will affect its normal use. If the bearing is too dry, it is likely to cause damage to the equipment.

After the twin-screw extrusion granulator has been used for a period of time, all parts need to be inspected in detail to see if any parts are loose and if there is any need for reinforcement. If some parts are seriously worn, they need to be replaced in time.

After the twin-screw extruder granulator works for a period of time, the motor will heat up, so in order to ensure that its working heat can be dissipated normally, you must install the equipment in a well-ventilated place. If the installation location is not well ventilated or even humid, the heat of the motor cannot be dissipated, which will cause great damage to the twin-screw extrusion granulator. Perhaps the motor will be burned due to excessive temperature.